Hirobo HI2524003 Rod End Pin 2 x 45, pack of 10 pcs for RC helicopter linkage maintenance  [HI2524003]

Rod end pin for RC helicopter linkages

This is an RC-scale rod end pin supplied under Hirobo model HI2524003, sold as a pack of 10 pcs. The part is intended for use in general helicopter linkage assemblies where short replacement pins are needed to secure ball links or small clevises.

Use this pin when replacing worn linkage fasteners, when adjusting control throw, or when carrying lightweight spares for field repairs. Its naming (2 x 45) indicates the size reference provided in the product title, so confirm fit against your linkage length and retaining method before installation.

Installation is straightforward: remove the retaining clip or fastener on the original pin, slide out the old pin from the linkage or ball link, position the new HI2524003 pin through the linkage, and re-secure with the original clip or retainer. Check free movement of the joint after assembly and verify there is no binding at full throw.

In tuning or setup, these pins act as basic mechanical connectors rather than adjustable components; they are useful for repeatable linkage geometry during setup changes and for keeping spare parts on hand during practice or field sessions.