Hirobo HI2539030 Guide Pin M2.6 x 5 for Helicopter General Parts  [HI2539030]

Guide pin for Hirobo helicopters

This HI2539030 guide pin is an RC-scale accessory intended for use within Hirobo helicopter general parts. It functions as a locating and alignment pin for small assemblies where precise positioning reduces play and helps maintain gear and rotor alignment during setup and light tuning adjustments.

Compatibility is limited to general Hirobo helicopter components classified under pins and general parts, as indicated by the product category. Do not assume fitment to specific airframes or model kits unless those parts explicitly reference HI2539030.

Installation is straightforward: fit the pin into the corresponding locating hole so that mating parts seat squarely, then secure with the original fastener or retaining method used by the assembly. During installation check for lateral play and confirm that the pin does not bind rotating elements; the pin's role is to stabilise alignment rather than to carry heavy loads.

For tuning and maintenance, treat the guide pin as a wear item: inspect for bending, scoring, or corrosion when you service the helicopter, and replace if it introduces play into the joint. Keeping mating holes clean and free of debris helps the pin maintain accurate positioning.