HPI Baja Alloy Roof Scoop by GPM BJ001  [BJ001]

Roof scoop for HPI Baja

This is an RC-scale alloy roof scoop produced for the HPI Baja platform, intended to sit on the vehicle roof to influence airflow and thermal behaviour of the body shell. The part is described as an alloy roof scoop and is sized for HPI Baja bodies, offering a rigid mounting point and a low-profile profile suited to off-road use.

Installation is straightforward on bodies that expose standard roof fixing locations: align the scoop with existing body holes or mounting pads, secure with the vehicle's original hardware or equivalent fasteners, and trim the shell if required to clear internal components. The scoop's role is primarily aerodynamic and cooling-related, not structural; verify clearance to antennas, roll cages, or interior electronics before final fitting.

For tuning, use the scoop to alter how air flows across the shell at speed. Small changes to scoop angle or position relative to the body can shift airflow patterns, which may affect front/rear balance and cooling paths to components such as the ESC or motor in RC setups. Always check for rubbing or contact after first test runs and readjust as needed.

As an aftermarket alloy roof scoop for HPI Baja RC buggies, this part provides a durable option for airflow tuning and shell refinement. Use conservative trimming and trial runs to confirm the intended effect on handling and cooling.