HPI Bullet 3.0 MT and ST Alloy C-Hub by GPM BMT019  [BMT019]

Alloy C-Hub for HPI Bullet 3.0 MT/ST

This is an RC-scale replacement C-hub designed for the HPI Bullet 3.0 MT and ST platforms, supplied by GPM under model BMT019. The part uses aluminum alloy construction to provide a dimensionally stable mounting point for front steering components on nitro-powered short-course and monster truck style models.

The alloy C-hub serves as a direct swap for the factory steering hub on compatible Bullet 3.0 MT and ST assemblies, preserving stock mounting geometry while offering a firmer interface for the steering knuckle and tie-rods. It is intended for hobby use on RC models and not for any full-size vehicle applications.

Installation notes: the component is intended to fit the Bullet 3.0 MT and ST steering assemblies without modification, using the original mounting locations and fasteners. Check fitment and local hardware condition during replacement, and verify steering travel and toe settings after installation to maintain safe handling on your RC model.

Use this alloy C-hub when replacing worn steering hubs or when seeking a more rigid steering mounting point for tuning steering response on the Bullet 3.0 MT and ST RC models.