This is an alloy front suspension arm designed for RC-scale use on HPI Bullet 3.0 MT and ST chassis. The part provides a direct replacement for the stock front arm and is intended for front-end suspension maintenance, repair, or setup work. It is sold as a 1pr set suitable for hobby-grade nitro buggy setups.
Installation requires basic RC tools such as hex drivers and standard hardware; existing mounting pins and ball studs from the stock arm are normally reused unless damaged. The alloy construction increases structural stiffness compared with standard plastic arms, which can affect steering feedback and suspension response, so allow for modest setup adjustments after fitting.
The alloy front suspension arm is an RC-scale replacement part aimed at hobbyists needing a durable front arm for the HPI Bullet 3.0 MT and ST chassis. Use it when repairing damaged arms or when adjusting front-end rigidity as part of suspension tuning, and verify fit with your existing steering linkage and mounting hardware.
Copyright © 2008-2026 rcjaz.com All rights reserved
