HPI Bullet 3.0 MT/ST Front Tire and Beadlock Rim Set by GPM BMT1003F+889  [BMT1003F+889]

Front tires and beadlock rims for HPI Bullet

This GPM aftermarket set supplies rubber front tires mounted on nylon rim frames with alloy 10‑pole beadlock rings and includes 12x9mm drive adapters for use with HPI Bullet 3.0 MT and ST nitro chassis. The package is an RC‑scale replacement designed to restore steering feel and allow straightforward front‑end tuning without modifying the vehicle’s original hub geometry.

Installation requires removing the stock front wheels, fitting the 12x9mm drive adapters to the existing hex/axle interface, seating the tire on the nylon rim, then securing the alloy beadlock ring with the supplied hardware. The components are intended to work with standard HPI Bullet 3.0 MT and ST nitro front hubs; verify adapter size before fitment.

For tuning, the rubber compound and beadlock construction let you adjust tire seating and small stagger changes while maintaining durable rim structure: nylon frames reduce impact damage risk, and alloy 10‑pole beadlocks keep the tire clamped for more consistent steering response on mixed surfaces. Routine checks of beadlock fasteners and adapter tightness are recommended after the first runs.

Use this set to replace worn front tires or to test minor front‑end setup changes on HPI Bullet 3.0 MT/ST nitro models; keep beadlock screws checked and avoid over‑tightening the adapters to prevent hex or axle damage.