HPI Bullet 3.0 MT and ST Rear Tire and Rim Set by GPM BMT1003R+889  [BMT1003R+889]

Rear tires and beadlock rim set

This is an RC-scale rear tire and rim replacement set designed for HPI Bullet 3.0 MT and ST running Nitro engines. The kit pairs rubber rear tires with nylon rim frames and alloy 10-pole beadlock rims, and includes 12x9mm drive adapters to match compatible wheel hubs. The package comes as a single pair set suitable for replacing worn rear wheels or converting a spare wheel setup to beadlock-style rims.

Intended role: these components are intended as direct-fit spares and hop-ups to restore rear traction and allow secure mounting of tires with beadlock clamping. The nylon frames keep weight low while the alloy beadlock rings provide mechanical clamping for the rubber tires. The included 12x9mm drive adapters bridge the rim assembly to the vehicle driveline where that axle specification is used.

Fit and installation notes: verify axle and hub dimensions before fitting, confirm the vehicle uses 12x9mm drive interface, then mount the rim assembly to the hub using the supplied adapters and torque hardware to manufacturer recommendations. Check wheel runout and bead seating after installation and re-check fasteners after the first run.

Use this set when replacing worn rear tires or upgrading to beadlock-style rims for consistent mechanical clamping; confirm fitment with your chassis before purchase.