HPI Bullet 3.0 Mt And St spring steel tie rod set with plastic ends 7pcs by GPM BMT160ST  [BMT160ST]

Tie rod set for HPI Bullet 3.0 MT/ST

This replacement tie rod set is made as a direct-fit aftermarket linkage pack for HPI Bullet 3.0 MT and ST nitro chassis. The kit focuses on basic steering and suspension linkage function, using spring steel rods with molded plastic end fittings to retain pivot and thread engagement while keeping weight low.

The set contains 7pcs configured to replace worn or damaged tie rods commonly found in steering assemblies and suspension linkages. Parts are intended for scale RC use only and are supplied as identical aftermarket replacements to restore geometry and adjustability without altering original chassis design.

Installation notes: inspect existing ball sockets and threads for wear before fitting, replace any degraded ends or bearings as needed, and thread tie rods to match the original length and toe settings on the chassis. Adjust incrementally and verify free articulation of the suspension and steering to avoid binding.

Use this set to replace fatigued linkages and regain consistent steering response; verify fit and alignment after installation and cycle the suspension to confirm smooth operation.