HPI Bullet 3.0 MT/ST alloy front/rear shock tower set by JAZRIDER BUL-18005-BK  [BUL-18005-BK]

Alloy front/rear shock tower set

This is an RC-scale alloy front and rear shock tower set with an integrated body mount, supplied as 1 pcs. The part is designed for HPI Bullet platform models listed as Bullet 3.0 MT and ST in available parts catalogs. Constructed from machined alloy, the tower replaces stock plastic mounts to provide a firmer mounting point for shock absorbers and the body mount interface while keeping overall weight low.

The component's role is straightforward: it secures the top of the suspension assembly, helps maintain consistent shock geometry under load, and gives a stable anchor for the body mount. For model fitment, confirm your chassis matches the Bullet 3.0 layout and existing mounting hole pattern before installation. Use common RC maintenance practices when removing stock parts and fitting alloy replacements to avoid damaging threads or related mounting hardware.

Installation notes: this accessory installs at the factory shock tower locations and uses the vehicle's original mounting points and hardware unless alternate fasteners are specified by your chassis documentation. When tuning suspension, the stiffer mounting surface can change shock response slightly, so re-check ride height and damping after fitting.