This front adjustable tie rod is a direct-fit RC-scale part for HPI Bullet 3.0 MT and ST nitro models, supplied as a single pair. It uses spring steel for the rod body and alloy end fittings to preserve thread integrity at the connection points, and features an anti cross-thread 4mm design. The assembly extends from 73mm up to 80mm, giving a straightforward length range for basic steering geometry changes.
Functionally this tie rod serves the steering link role: altering track toe and reducing slop in the front linkage when worn plastic parts are replaced. The adjustable length lets you make small toe-in or toe-out changes without replacing fixed-length links, which helps dial in handling on different track surfaces or after suspension changes.
Installation notes: the part is intended for RC-scale use on the specified HPI chassis. When fitting, align the threads and confirm the alloy end fittings seat cleanly against the steering knuckle and bell crank. Verify both sides match length and movement before running the model. Periodic inspection of thread engagement and end-fit tightness is recommended after initial runs to catch any loosening or wear.
Copyright © 2008-2026 rcjaz.com All rights reserved
