This graphite radio tray is an RC-scale replacement part produced for the HPI Bullet 3.0 MT and ST platforms with Nitro engines. It serves as a dedicated mounting surface for the receiver, servo and related small electronics, keeping wiring tidy and components secured inside the chassis layout used by these models.
Material and finish are stated as graphite with a blue coating; the tray is intended to sit in the vehicle's radio bay following the original mounting pattern for Bullet 3.0 MT and ST layouts. The design focus is on a stiff, low-profile panel that aligns with common 1/10 off-road component positioning rather than adding bulk.
Installation notes: the tray is supplied as one piece, it should be mounted using the chassis' existing screw points where compatible, and routing for antenna and power leads should follow the model's stock paths. Check clearance around the servo and fuel tank on Nitro-equipped Bullet 3.0 MT/ST variants before final tightening.
Role in tuning and setup: use this tray to maintain consistent radio placement during setup and track work, and to simplify swapping or servicing the receiver and servo during maintenance sessions without altering primary chassis geometry.
Copyright © 2008-2026 rcjaz.com All rights reserved
