HPI Bullet chassis alloy front/rear shock tower set by JAZRIDER BUL-18005-GU  [BUL-18005-GU]

Alloy front/rear shock tower for Bullet

This is an RC-scale alloy front/rear shock tower set designed for the HPI Bullet chassis, supplied as 1 pcs in gunmetal finish. The single-piece tower integrates body mount points and provides a stiffer mounting location for shock absorbers and the body posts compared with stock plastic towers.

Functionally the part is used to increase rigidity at the suspension mounting area and to stabilise body mount points during cornering and impact. In tuning terms it alters how the suspension loads through the tower, helping maintain consistent shock geometry under load.

Installation is straightforward for experienced builders: the tower replaces the original front and rear shock tower locations using existing chassis mounting points, and it commonly reuses the same screws and body posts. During fitment check alignment of shock shafts and body mounts before final tightening to avoid binding. No additional tools or hardware are included unless stated by the retailer.