HPI Bullet Flux Orange Alloy Center Bulkhead Set by JAZRIDER BUL-18006-OR  [BUL-18006-OR]

Center Bulkhead Set for HPI Bullet Flux

This center bulkhead set is an RC-scale replacement and hop-up part intended for the HPI Bullet Flux family. Machined from aluminium alloy with an orange anodized finish, the component focuses on center chassis support and a firmer mounting point for drivetrain and suspension linkages without altering original geometry.

Fitment targets Bullet Flux MT and ST variants as listed in product documentation, serving as a direct replacement for the center bulkhead on compatible chassis. The part supports tuning workflows that adjust chassis stiffness and response by providing a more rigid central mounting structure compared with some stock plastic components.

Installation is straightforward for experienced model technicians: remove the original center bulkhead, transfer any reusable hardware where applicable, and secure the alloy unit using the original mounting points. After fitting, check alignment of drivetrain and suspension pivots and confirm fastener security before running the model.

Regular inspection of fasteners and mating surfaces is recommended; aluminium alloy parts can extend service life but still require periodic checks after track or field use to maintain reliable performance.

Use this alloy center bulkhead when you need a durable, visually distinctive replacement that supports chassis tuning and consistent alignment on HPI Bullet Flux platforms.