HPI Bullet FLUX Orange Alloy Steering Assembly by JAZRIDER BUL-18002-OR  [BUL-18002-OR]

Alloy steering assembly for Bullet FLUX

This is an RC-scale steering assembly set finished in orange alloy designed for HPI Bullet FLUX chassis. The assembly is intended to replace worn plastic steering parts or to provide a firmer steering linkage with integrated bearing support to reduce play. The component is presented as a chassis-level hop-up that affects steering precision and linkage stability rather than motor or drivetrain performance.

Installation notes

• Check the existing linkage and mounting points on the Bullet FLUX MT or ST, remove the stock steering knuckles, and fit the alloy assembly in the same locations.
• Retain or reuse compatible mounting hardware where possible, confirm clearance with your servo horn and tie-rods before final tightening.
• After installation, center the steering and verify toe settings and free travel to ensure predictable steering response.

Tuning role

• Using alloy knuckles with bearings can reduce slop at the steering pivot, improving repeatability for track setups or precise yard testing.
• Pair with appropriate servo settings and linkage geometry adjustments to balance steering speed and stability.