HPI Bullet Front Chassis Gunmetal Alloy Brace by JAZRIDER BUL-18004-GU  [BUL-18004-GU]

Front chassis brace for HPI Bullet

This RC-scale front chassis brace is designed for the HPI Bullet line and offered by JAZRIDER under model BUL-18004-GU. The component is a gunmetal alloy front chassis brace intended to add targeted stiffness to the front section of the chassis, allowing drivers to refine handling and balance in chassis setup.

The brace mounts to the existing front chassis attachment points and is intended to integrate with the Bullet 3.0 MT and ST nitro chassis layout without altering basic geometry. Its role in tuning is conservative and specific: adjust front-end stiffness to influence turn-in and front grip characteristics during setup changes.

Installation notes: this is an RC-scale replacement/upgraded brace that fits the listed Bullet chassis variants; confirm alignment with your chassis mounting points before fitment. The part should be treated as a structural hop-up for tuning, not a full chassis replacement.