HPI Bullet Orange Alloy Front Chassis Brace by JAZRIDER BUL-18004-OR  [BUL-18004-OR]

Front chassis brace for HPI Bullet

This JAZRIDER BUL-18004-OR front chassis brace is an RC-scale alloy reinforcement designed to replace the standard front brace on HPI Bullet models. It is intended to increase front-end rigidity and reduce flex where the front suspension and chassis meet, helping drivers refine steering response and balance without altering core suspension geometry.

Compatibility is focused on HPI Bullet 3.0 MT and ST nitro models, so confirm the Bullet chassis variant before fitting. The part is made from orange anodised alloy, offering a dimensionally stable, low-profile brace that integrates with existing mounting points on the Bullet front bulkhead and shock tower areas.

Installation is straightforward for hobbyists familiar with disassembly of the front end: remove the original brace, align the alloy brace to factory holes, and secure with the original fasteners for a direct fitment. Expect no changes to servo, ESC, or motor placement; the brace affects structural stiffness rather than drivetrain layout.

In tuning terms, this brace is a front-end stiffness option rather than a suspension component: use it when you need crisper turn-in or reduced chassis flex under braking and acceleration on 1/8-scale nitro tracks. It pairs with standard Bullet setup changes like anti-roll bar tuning or shock valving to fine-tune on-track behavior.