HPI Savage 21 Graphite Steering Plate with Screws by GPM GSAV1049  [GSAV1049]

Graphite steering plate for Savage 21

This is an aftermarket graphite steering plate designed for HPI Savage 21 RC models, supplied as a 1 pcs set with the required screws included. The part is intended as a direct replacement for the stock steering plate where compatible, offering a stiffer mounting surface that helps refine steering feedback without changing core steering geometry.

Installation is straightforward for hobbyists familiar with basic chassis maintenance: remove the original plate, fit the graphite unit using the supplied screws, verify steering linkage alignment and neutral throw, then check for binding across the steering range. No special tools beyond common hex drivers are required, but confirm screw fit and thread engagement before final tightening.

In tuning terms this plate is used to adjust front-end stiffness and steering feel; swapping between stock and graphite plates is a common way to fine-tune how the vehicle responds to servo input and track conditions. As an RC-scale accessory it is aimed at routine maintenance, small upgrades, and setup variations rather than structural chassis modification.