HPI Savage 21 Titanium Hinge Pins with E-clips by GPM TSAV1101  [TSAV1101]

Titanium hinge pins for Savage 21

This hinge pin set is an RC-scale replacement designed for the HPI Savage 21 platform, supplied by GPM under model TSAV1101. The package pairs hardened pins with matching E-clips to secure suspension and body linkages where the original hinge pins may wear or bend through regular running.

Installation is straightforward: remove the worn pins from the axle or suspension arm, seat the new titanium pins in the same holes, and secure each pin with the supplied E-clip. The parts are intended for hobby-level maintenance and tuning; basic hand tools such as a small plier or E-clip tool are sufficient to fit or remove the clips.

In a tuning context, these pins act as low-mass retention hardware that can reduce play at pivot points and hold alignment under higher loads. Titanium offers a balance of strength and corrosion resistance compared with standard steel pins, helping maintain consistent suspension geometry during repeated runs.

Use these pins as direct replacements to restore secure pivot points on an HPI Savage 21 or when upgrading worn hardware; they fit standard hinge locations and are fitted with E-clips for retention.