HPI Savage Alloy Steering Knuckles by JAZRIDER JR-CHP-SAV-018  [JR-CHP-SAV-018]

Alloy steering knuckles for Savage

This JAZRIDER JR-CHP-SAV-018 steering knuckle set is an RC-scale replacement part designed for HPI Savage Nitro Off Road series models. Machined from aluminium alloy and supplied in purple, the component is intended for use where a metal steering knuckle is preferred for its rigidity and resistance to wear compared with common plastic alternatives.

The part functions as the steering upright where the wheel hub, steering linkage, and suspension components interface. In tuning terms, owners typically consider alloy knuckles when targeting more consistent steering geometry under load and when reducing flex at the steering pivot is part of the setup strategy.

Installation generally follows standard front-end service: remove the wheel and hub carrier, swap the knuckles in place of the stock items, and secure with the existing mounting hardware. Verify fastener torque and check clearances for driveshafts and bearings after fitment. As with any hop-up, confirm fit against your exact Savage model variant before installation.

Compatibility

Compatible with HPI Savage Nitro Off Road Series models as stated; confirm fit with your specific Savage variant before purchase.

This JAZRIDER aluminium steering knuckle is a straightforward hop-up for Savage owners seeking a metal alternative at the steering pivot, offering a neutral option for durability-focused tuning and routine replacement needs.