HPI Savage Chassis Alloy Front and Rear Chassis Mount by JAZRIDER JR-CHP-SAV-002  [JR-CHP-SAV-002]

Alloy Front & Rear Chassis Mounts

This alloy front and rear chassis mount set is made for the HPI Savage Nitro off-road series and is supplied in a purple anodised finish. As a scale RC accessory, it replaces common plastic or composite mounts to offer a metal mounting point where builders want consistent alignment and reduced flex at the chassis/gearbox interface.

The parts are machined from aluminium alloy to balance stiffness and weight for on-track durability at model scale. They are intended to use the vehicle's stock mounting locations so the swap typically aligns with factory holes and mounting planes. This makes the parts suitable for hobbyists focused on tuning chassis rigidity and improving repeatable setup changes.

Installation notes: the mounts are intended to interface with existing Savage Nitro chassis points and fasteners, check fitment against your chassis before final tightening, and verify suspension travel and drivetrain alignment after fitting. These mounts are an accessory for RC models only and are not for full-size vehicles.

The JAZRIDER JR-CHP-SAV-002 chassis mounts offer a straightforward aluminium upgrade path for HPI Savage owners seeking firmer mounting points and a consistent chassis feel, while retaining stock mounting geometry for minimal changes to the vehicle's baseline setup.