HPI Savage Fluorescent Slipper Clutch Pad by GPM SAVSCP  [SAVSCP]

Slipper clutch pad for HPI Savage

This is an RC-scale slipper clutch pad intended as a replacement part for HPI Savage / Savage variants. The pad uses a fluorescent material for easier visual inspection during setup and maintenance, and is supplied as 1 pcs.

Functionally the pad sits between the slipper hub and clutch faces to control slip characteristics. It is intended to work as part of the slipper assembly to influence engagement feel and to assist fine tuning of slipper nut preload and spring selection. Always treat this as an RC model component and verify fit with your existing slipper hub and assembly before final installation.

Installation notes: remove the slipper assembly from the gearbox or clutch housing, swap the worn pad for the replacement, verify seating and alignment, then reassemble and test engagement at low throttle. Inspect hub faces and springs for wear while replacing the pad.