This replacement alloy front/rear C‑hub is intended for hobby‑scale HPI Savage platform vehicles and serves as the steering knuckle mounting point in the suspension assembly. The part is offered as an aftermarket upgrade to restore damaged C‑hubs or to refresh worn steering linkages without implying any real vehicle application.
Constructed in aluminum alloy, the unit accepts standard king pins and is supplied with the matching small hardware items needed to secure the hub to the steering arm and axle mounts. Using alloy C‑hubs can help maintain alignment under load and reduce play compared with heavily worn plastic components.
Installation notes: check king pin fit and e‑clip seating, ensure fasteners are torqued to serviceable tightness consistent with your chassis hardware, and verify wheel alignment and toe after installation. Avoid over‑tightening pivot screws to prevent binding in the steering assembly.
Use this GPM alloy C‑hub to replace worn front or rear knuckles on supported Savage variants, carry out alignment checks after fitment, and retain spare king pins and e‑clips for routine maintenance.
Copyright © 2008-2026 rcjaz.com All rights reserved
