HUDY 107871-S adhesive foam strip 1.0mm, 2 pcs  [HSP-107871-S]

Adhesive foam strip for R/C bodies

This HUDY 107871-S self-adhesive foam strip is an RC-scale accessory supplied as a set of 2 pcs with the measured size 1x13x155mm and a nominal thickness of 1.0mm. The product is intended for use on model car bodies and interior padding where thin, conforming foam is needed to control fit, reduce rattles, or protect painted surfaces.

Compatibility is broad and general: the strip is suitable for use on most R/C body shells and internal panels that accept thin adhesive tape. No chassis- or brand-specific claims are made; evaluate fit against your particular body contours before final installation.

Installation is straightforward: peel the protective liner, align the foam strip along the intended edge or contact surface, press firmly to seat the adhesive, and trim to length with a hobby knife or scissors. Placement notes: use light pressure to avoid shifting painted surfaces, and allow adhesive to set before rehousing electronics or exposing the model to track conditions.

From a tuning perspective this foam strip serves three practical roles: providing a thin cushion to reduce vibration transfer, filling small gaps at body mounting points to improve aerodynamics and fit, and protecting delicate paint or decals from contact wear. Because the material is low-profile at 1.0mm it’s best for fine adjustments rather than bulk padding.