The JAZRIDER JR-TA105-GU is an aluminum rear shock tower intended for 1/10 scale RC cars using Tamiya TA01 or TA02 chassis patterns. The gun metal finish provides a corrosion-resistant surface while keeping a low-profile look on the rear bulkhead area of the chassis.
This replacement tower is produced as an RC-scale accessory to match the TA01 and TA02 rear mounting layout, allowing direct installation where the original plastic tower locates. Its role is purely in chassis mounting and tuning, delivering a firmer mounting point for shocks and helping preserve alignment under load compared with stock plastic parts.
Installation notes: remove the rear bodywork and original tower, transfer any existing mounting hardware without altering the chassis, and fit the tower so that shock absorbers and linkage clearances are maintained. After fitting, verify shock travel and wheel alignment before running to ensure the geometry matches your setup goals.
Tuning role: upgrading to an aluminum tower provides a stable mounting surface that can reduce flex at the rear mounting points, which helps when changing shock positions or experimenting with roll stiffness and damping balance. It is intended for incremental setup adjustments rather than wholesale changes to chassis behavior.
Copyright © 2008-2026 rcjaz.com All rights reserved
