JAZRIDER JR-THNE06-BK Aluminum Gear Box for Tamiya DT02/DT03/DT04/Hornet EVO (Black)  [JR-THNE06-BK]

Aluminum gear box for Tamiya DT series

This JAZRIDER JR-THNE06-BK aluminum gear box is an RC-scale replacement housing designed for direct fit on Tamiya DT02/DT03/DT04 and Hornet EVO platforms. The unit is a single-piece housing supplied in black anodized finish intended to replace the stock plastic case where riders seek improved rigidity and consistent gear mesh.

Compatibility is limited to the models listed above; bearings, spur and pinion gears from the original assembly are reused unless specified otherwise by your build. The machined aluminum body helps maintain alignment under load and can aid cooling compared with standard plastic housings, while adding modest mass that affects chassis feel and balance.

Install notes: transfer the existing internal components and fasteners from the original gear box, check bearing seating and gear mesh during assembly, and verify clearance with the motor mount and suspension linkages before final tightening. The part is presented as a direct chassis-level hop-up rather than a complete drivetrain kit.

Use this JAZRIDER JR-THNE06-BK gear box when replacing a worn plastic housing or when seeking a stiffer mounting point for drivetrain tuning on supported Tamiya DT platforms; confirm parts transfer and gear alignment during installation.