JAZRIDER JR-THNE06-RD Aluminum Gear Box for Tamiya DT02 DT03 DT04 Hornet EVO (Red)  [JR-THNE06-RD]

Aluminum replacement gearbox for Tamiya DT-series and Hornet EVO

This aluminum gear box is a direct aftermarket replacement designed for RC-scale use on Tamiya DT02, DT03, DT04 and Hornet EVO platforms. The JR-THNE06-RD housing replaces the stock plastic case to provide a stiffer mounting point for spur and pinion alignment while maintaining original gear locations and service access.

The part is constructed from red anodized aluminum and serves as a structural hop-up that helps stabilise gear mesh under higher loads and during extended runs. Installation follows the vehicle's standard gearbox disassembly, allowing reuse of existing spur gear, pinion gear and internal bearings where compatible.

Practical notes: verify compatibility with your chassis by confirming model designation before purchase, keep original bearings and fasteners checked for wear, and use a thin layer of light gear grease on gear teeth to reduce wear after installation.

The JR-THNE06-RD is intended as a direct-scale upgrade to improve rigidity and serviceability on compatible Tamiya DT-series and Hornet EVO drivetrains, supporting routine tuning and maintenance without altering gear ratios.