Kyosho CL005 Shock Stay & Panhard Rod Mount (KC10) rear shock stay and panhard rod mounting bracket for KC10 chassis  [KY-CL005]

Rear shock stay and panhard mount for KC10

This Kyosho CL005 Shock Stay & Panhard Rod Mount is an RC-scale replacement mounting bracket designed for the KC10 chassis. It consolidates the rear shock stay and the panhard rod mounting points into a single component, providing a defined mounting location for rear suspension linkages and alignment reference for chassis setup.

Intended role and fitment are straightforward: the part aligns with the KC10 rear subframe mounting areas and serves as a structural anchor for the shock bottoms and panhard rod. When fitted it affects rear suspension geometry and lateral axle positioning, so it is used primarily as a tuning item to refine handling balance rather than a performance mod by itself.

Installation notes: remove the rear bodywork and follow chassis disassembly steps to access the rear mounting area, retain original hardware where applicable, and verify alignment and free movement of the suspension after fitting. Check link angles and pivot clearances during reassembly to avoid binding.

Maintenance and tuning tips: inspect mounting faces for wear or looseness after hard use, check fastener torque periodically, and use this bracket to experiment with small changes in panhard rod location and shock mounting to tune roll center and cornering response on RC-scale tracks or practice sessions.

Compatibility

Designed specifically for the Kyosho KC10 chassis and intended for use on KC10-based RC-scale models.