Kyosho CL012 Front & Rear Bumper for KC10 chassis replacement  [KY-CL012]

Front and rear bumper for KC10

This Kyosho CL012 set provides front and rear bumper pieces intended as direct replacement parts for the KC10 radio‑control chassis. The content focuses on practical fitment and service use so you can restore impact protection and basic front/rear geometry after on‑track incidents.

Compatibility is limited to the KC10 chassis platform, the parts are scaled for RC use and meant to mount where the original bumpers attach. When replacing, inspect existing mounting points and retain any factory screws or brackets that remain serviceable, use appropriate-sized hex driver and hardware to avoid overtightening.

From a tuning and setup perspective these bumpers serve to protect the nose and tail sections during routine running and minor collisions, they do not alter suspension or steering geometry by themselves but can affect crash behavior and weight distribution when combined with other chassis changes.

For maintenance, clean mounting interfaces before assembly and check for stress cracks after hard impacts; replace the set if deformation compromises fit or alignment.