Kyosho CL015 - AL Servo Horn (KC10/25T) AL servo horn for KC10 chassis steering linkage  [KY-CL015]

AL Servo Horn for KC10

This AL servo horn is a dedicated replacement part for KC10 chassis setups, described here as an RC-scale accessory for on-road 1/10 projects. The piece serves as the interface between the servo spline and the steering linkage, providing a stable mounting point that affects steering throw and mechanical response.

The design focus is functional rather than decorative: a single-piece aluminum horn to replace worn or plastic stock arms, reducing play at the servo output and offering consistent input response during tuning. Because it is an RC accessory component, installation requires matching the servo spline type and checking clearance with surrounding steering rods and suspension elements.

Installation notes: remove the existing horn from the servo output, verify spline alignment and fit, then secure the AL horn to the servo using the original mounting screw(s). When fitting, cycle the steering to inspect for binding against the KC10 steering assembly and adjust linkage lengths or tie-rod positions as needed to restore neutral alignment.

Tuning role: this horn provides a firmer connection point for fine adjustments to steering geometry and endpoint settings. Swapping to a rigid aluminum horn can reduce flex under load, which helps maintain consistent steering ratios during cornering and under braking on paved RC tracks.

For hobbyists maintaining or tuning a KC10 on-road rig, this horn is intended as a straightforward, serviceable replacement to improve mechanical consistency at the servo interface.