Kyosho CL019 Wheel Hub (KC10, 4pcs)  [KY-CL019]

Wheel hub for KC10 chassis

This Kyosho CL019 wheel hub is a direct spare for the KC10 chassis supplied as a 4pcs set, intended for RC-scale wheel mounting and routine upkeep. The description here focuses on fit, installation considerations, and how the hubs relate to handling and wheel alignment in model setups.

Compatibility: designed for the KC10 chassis family, the parts are supplied as a matched set to keep wheel fitment consistent across both sides of an axle. Check existing hub geometry and wheel hex dimensions before fitting to confirm alignment and clearances.

Installation notes: remove the wheel and existing hub, inspect axle and wheel hex for wear, fit the CL019 hub ensuring correct seating and torque on retaining hardware, and verify free rotation without binding. When reassembling, confirm that wheel offset and track width remain within your desired setup to preserve handling balance.

• Tip: Reuse compatible wheel hexes and fasteners to maintain original offset unless you are intentionally changing track width.
• Tip: Inspect wheel bearings for play during hub replacement to avoid masking bearing issues with a new hub.
• Tip: After installation, perform a short test run and recheck fastener torque and wheel runout.

Compatibility

• KC10 chassis

Use these hubs to restore correct wheel mounting on KC10 models or to keep a set of spares for quick maintenance between sessions, focusing on consistent fit and predictable handling.