Kyosho CL022 - Front Shaft (KC10/L/R 1pc each)  [KY-CL022]

KC10 front shaft spare part

This Kyosho CL022 front shaft is an RC-scale replacement component intended for use with the KC10 chassis, supplied as one piece per specified wheel position (KC10/L/R). It is presented as a direct spare part to restore or maintain the front drivetrain linkage and steering input path without altering original geometry.

Fitment and role: this front shaft matches the KC10 series mounting points and is designed to occupy the same bearings and retainers as the original component, so it is primarily used during routine maintenance, repairs after wear, or to replace damaged shafts following impact.

Installation notes: remove wheel and any hub halves as required by the KC10 service procedure, then slide the shaft through the front drivetrain carriers and secure with the original retainers and screws. Check alignment and free rotation of the driven components before reassembling the wheel to avoid binding.

Tuning considerations: swapping a worn shaft back to service helps preserve consistent steering response and reduces slop in the front end, supporting repeatable handling during setup and track tuning. After replacement, verify toe and camber settings under static load and perform a short test run to confirm behaviour.