Kyosho CL025 - Front Suspension Link-rod (KC10) Replacement front link for KC10 chassis  [KY-CL025]

Front suspension link for KC10

This front suspension link-rod is an RC-scale replacement part specified for the KC10 chassis, intended to restore or maintain correct linkage between the steering knuckles and the suspension assembly.

The component's role is straightforward: it connects the steering/suspension pivot points, influences toe and roll centre behaviour, and provides a serviceable mounting point for fine-tuning alignment during setup. Use it when replacing worn linkages or when adjusting front-end geometry for handling changes.

Installation notes: remove the damaged link from the KC10 front assembly, transfer any existing ball ends or rod ends as required, then fit the replacement link ensuring correct thread engagement and secure fasteners. Verify steering throw and suspension travel after installation at model scale before running.

Tuning role: changing link length or end position affects toe-in/toe-out and the initial steering response. Use small incremental changes and test on a prepared surface to evaluate handling differences in a controlled RC environment.