This Kyosho CL028 pivot ball set is an RC-scale replacement intended for the KC10 chassis, supplied as an 8pcs pack for routine maintenance and part refresh. The 5.8mm designation identifies the ball joint sizing used at steering and suspension connection points on the KC10 platform. This product is presented as a direct-fit accessory for RC models and should be handled as a model-scale component only.
Use this set to restore precise steering feel and to remove play that develops over time in pivot joints. During service, inspect ball cups and link ends for wear before assembly, replace worn parts, and ensure ball seating is clean for correct geometry. Because pivot play affects both steering accuracy and suspension behaviour, timely replacement can simplify setup and tuning.
Installation is typically done as part of front-end or suspension maintenance; disassemble the affected linkage, transfer or replace the ball into the cup or rod end, then reassemble and check for free movement without binding. After installation, confirm alignment and trim any excess thread engagement if applicable to preserve range of motion.
Copyright © 2008-2026 rcjaz.com All rights reserved
