Kyosho CL029 Pivot Ball 6.8mm (KC10/8pcs)  [KY-CL029]

KC10 Pivot Ball 6.8mm for Suspension and Steering

This Kyosho CL029 pivot ball pack is specified for the KC10 chassis and supplied as a set of 8pcs, sized 6.8mm to match the KC10 pivot geometry. It is a scale RC accessory intended to replace worn ball joints in steering and suspension linkages without altering chassis design.

Compatibility is limited to the KC10 chassis as stated in the product title. The parts are offered as replacement components for routine maintenance and part renewal; verify fit on your KC10 parts before final assembly.

Installation is a mechanical replacement process: remove the worn pivot balls from the ball cups, fit the 6.8mm units into the corresponding ball seats, and check for correct seating and acceptable free play. After installation, perform a control check of steering and suspension travel to confirm there is no binding or excess play in the joint.

In tuning and maintenance, these pivot balls serve as consumable wear items: replacing them can restore consistent joint geometry and help preserve predictable steering and suspension response during setup cycles.