Kyosho CL030 Pivot Ball 6.8mm Flange for KC10 chassis, 4pcs  [KY-CL030]

Pivot ball flange for KC10 chassis

This Kyosho CL030 pivot ball flange is a set of four pivot balls sized at 6.8mm intended for use with the KC10 chassis on RC-scale cars. The parts are supplied as a 4pcs pack and serve as replacement pivot points where the suspension or steering linkage uses a flanged pivot ball interface.

Functionally the flange-style pivot ball provides a defined mounting surface for linkages and knuckles, reducing lateral play compared with non-flanged alternatives when correctly seated. Use these parts to restore tightness in worn joints or to maintain consistent steering and suspension geometry after routine maintenance.

Installation notes: verify fitment into the existing steering knuckle or linkage housing on the KC10 chassis, clean mating surfaces before assembly, check for any leftover debris that could interfere with seating, and inspect the joint for free movement without excessive slop after installation. Replace all four pieces if multiple joints show wear to maintain balanced handling.

Tuning role: swapping worn pivot balls can reduce unwanted play and improve steering precision and suspension responsiveness. When adjusting toe or camber, ensure pivot interfaces are free of binding to preserve predictable cornering behaviour.

This 4pcs pivot ball flange pack is a direct service item for KC10-based setups where 6.8mm flanged pivot balls are specified, used to refresh linkage points and sustain consistent handling characteristics on RC scale cars.