This Kyosho CLTH002SC-40 assembly is an RC-scale wheel and tire set designed for the KC10 chassis, supplied as a pair (2 pcs) with pre-glued tires mounted on chrome-plated spoke beadlock rims. The wheel uses a spoke-style beadlock designed for 1.9" bead seating and arrives ready to mount without separate tire-gluing steps.
Installation is straightforward: fit the wheel to the KC10 wheel hub, secure the beadlock ring evenly, and verify tire seating around the 1.9" bead. Because the tires are pre-glued, focus on correct ring torque and wheel alignment rather than adhesive work; check runout and balance as part of routine setup to reduce vibration and improve handling.
In tuning and maintenance, the chrome-plated spoke surface is primarily an appearance and corrosion-resistant finish, so avoid abrasive cleaners that could damage plating. Periodically inspect the beadlock fasteners for looseness after initial runs and replace or service as necessary to maintain consistent performance.
This wheel and tire pair is intended as a direct-replacement or upgrade for KC10-based RC models where a 1.9" spoke beadlock style and pre-glued convenience are desired.
Copyright © 2008-2026 rcjaz.com All rights reserved
