KYOSHO FW05-R/FW05RR Anti-Roll Bar Male & Female by 3Racing FW05-008A  [FW05-008A]

Anti-Roll Bar Male & Female for FW05-R/FW05RR

This 3Racing FW05-008A accessory provides male and female anti-roll bar end fittings intended for Kyosho FW05-R and FW05RR chassis use in RC models. The parts serve as direct connection points between the anti-roll bar and the linkage, preserving factory attachment geometry while allowing straightforward replacement or swapping during setup changes.

The article focuses on fitment, installation considerations, and the tuning role these ends play in roll control. These items are RC-scale components designed for model suspension tuning only and are not for full-size vehicles.

Installation notes: remove the wheel and loosen the suspension linkage as required to access the anti-roll bar ends, inspect existing hardware for wear, then fit the male and female ends to the appropriate rod or bar. Hand-check clearance through full suspension travel before final tightening. Use thread locking only where recommended by your chassis manual.

Tuning role: swapping or replacing these link ends can affect how the anti-roll bar transfers load into the suspension, so use them when adjusting understeer/oversteer balance or chassis roll response during track testing. Small iterative changes and test laps will reveal the practical effect on handling.