Kyosho FW-06 Aluminum One Way Hub by 3Racing FW06-09  [FW06-09]

Aluminum one way hub for FW-06

The Kyosho FW-06 Aluminum One Way Hub from 3Racing is an RC-scale driveline part designed for use with Kyosho FW-06 chassis layouts. As an aluminum replacement for the standard one way, its role is to provide a firmer interface between wheel hubs and the diff/axle assembly, affecting how drive torque is transferred under acceleration and during corner exit.

Installation is typical for one way hubs on the FW-06 platform: replace the original hub with the aluminum unit, verify correct seating and thread engagement, and check clearance with nearby suspension and steering components. No special tools beyond common hex drivers and the vehicle's wheel nut tools are required, but confirm torque values with your chassis manual to avoid over-tightening.

Tuning role: swapping to an aluminum one way hub changes mechanical stiffness and can alter traction characteristics and throttle response. Use it as part of a wider setup approach—adjust diff preload, slipper or clutch settings, and motor/ESC braking to match the altered drivetrain feel. Monitor wear on mating parts and re-check fasteners after initial runs.

This aluminum one way hub is intended for scale RC use on Kyosho FW-06 chassis where a stiffer hub is desired; consider it as a tuning element within a complete drivetrain setup.