KYOSHO Hyper 7 / RC8 Nylon Wheel for 1/8 Buggy (5 Poles) by GPM BUGW0105/G  [BUGW0105/G]

Nylon 5-pole wheel for 1/8 buggies

This GPM wheel (model BUGW0105/G) is offered as a direct aftermarket replacement produced for KYOSHO Hyper 7 and RC8 1/8 buggy platforms. Fabricated in nylon with a five-pole spoke layout, the item is sized and shaped for 1/8-scale buggy hubs and routines where hobbyists swap worn wheels or adjust wheel characteristics for handling changes.

The component role is straightforward: replace a damaged wheel, restore correct mounting geometry, or use the different spoke layout to alter wheel flex and response during setup changes. Installation is the same basic workflow used on most 1/8 buggies — remove the wheel nut, swap the wheel, and torque the nut to the chassis maker’s recommended value while checking hub alignment.

Sold as 1 pr, the wheel suits users who need a matched left/right set for a single axle. Because the item is a scale RC accessory, confirm hub hex size and mounting method on your Hyper 7 or RC8 before fitting, and use threadlocker or the original wheel nuts where applicable to secure the fit.