Kyosho IF613HB-01B - Rear Hub Carrier Bush Set (MP10)  [KY-IF613HB-01B]

Kyosho IF613HB-01B - Rear Hub Carrier Bush Set (MP10)
Price:
USD$12.62
Brand:
Kyosho
Model:
KY-IF613HB-01B
GTIN:
4548565470112
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $10.60 each $4.04 or 16%
3+ $10.07 each $7.65 or 20%
Write a review

Rear hub carrier bushing for MP10

This rear hub carrier bush set is an RC-scale replacement part for the Kyosho MP10 chassis, intended to restore correct lateral play and rotational alignment at the rear hub carriers. The set focuses on the hub-to-carrier interface rather than bearings or drive elements, so it’s used where worn or loose bushings affect handling and rear suspension geometry.

Installation is straightforward for anyone familiar with rear hub removal: remove the wheel and hub assembly, extract the worn bushings from the hub carrier, press or slide the new bushings into place using light, non-abrasive force, then reassemble with the existing hardware. Verify axle alignment and free rotation before final tightening.

In setup and tuning, these bushings help maintain consistent toe and camber under load by reducing unwanted slop at the hub carrier pivot, which is useful during suspension tuning sessions or after heavy track use. Regular inspection and cleaning of mating surfaces and adjacent走珠軸承 will prolong component life and ensure predictable rear-end behaviour.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What does this part replace on the MP10?

It replaces the bushings at the rear hub carrier pivot on the MP10, addressing play or wear where the hub carrier mounts to the suspension assembly.

Are any special tools required to fit the bushings?

No specialized tools are required, basic hand tools and a suitable press or gentle tapping method for seating the bushings are sufficient; use care to avoid deforming components.

Is this part compatible with other Kyosho models?

Compatibility is limited to the MP10 designation listed; verify fitment against your chassis before purchase as this set is intended for MP10 hub carriers.

How should I maintain these bushings for consistent handling?

Inspect for wear during routine maintenance, keep mating surfaces clean, replace if excessive play is found, and use light lubricant only where recommended to avoid attracting grit.

Copyright © 2008-2026 rcjaz.com All rights reserved