Kyosho IF732B - Wing Stay Set (MP11)  [KY-IF732B]

Wing stay set for MP11

This Kyosho IF732B wing stay set is the designated replacement for the Inferno MP11 chassis, serving as the mounting and support assembly for the rear wing. It is intended as a spare part to restore or maintain the wing's position and alignment on 1/8 scale RC buggies using the MP11 platform.

Compatibility is limited to the MP11 mounting layout; the component aligns with the chassis' stock wing posts and installs using the vehicle's existing fastener points. When replacing a worn or damaged stay, confirm the wing sits square and that mounting holes match the chassis to avoid twisting loads that affect handling.

From a tuning perspective the wing stay controls the fixed position of the rear wing and therefore contributes to rear downforce and high-speed stability. Small changes in stay geometry or how firmly the wing is clamped can influence handling balance, so check alignment after any setup change and before track use.

For upkeep inspect the stay for cracks or deformation and verify hardware torque at regular intervals. If the original screws or spacers are missing, source compatible hardware that matches the MP11 mounting points rather than altering the chassis.

Use this IF732B spare to maintain correct wing positioning on MP11 cars and to support consistent aerodynamic behaviour during setup changes and repairs.