Kyosho IFW709 One-piece Engine Mount Plate (MP11)  [KY-IFW709]

One-piece engine mount for MP11

This one-piece engine mount plate is an RC-scale replacement part intended for use with Kyosho Inferno MP11 series models. As a direct-fit spare, it replaces the chassis engine mounting interface and restores the factory single-piece mounting geometry on cars that use the MP11 engine bay layout.

Designed to serve a straightforward role in vehicle setup, the plate defines engine position, alignment, and the baseline for exhaust and clutch linkages. Fitting the part is a matter of removing the original mount and using the same mounting points and hardware from the chassis, maintaining stock mounting geometry without altering servo, ESC, or gearbox placements.

For tuning, this component acts as a stable reference when adjusting engine offset and centerline during clutch and pipe tuning sessions. Because it preserves factory alignment, it helps shops and hobbyists compare changes introduced by aftermarket mounts or engine shifts while keeping other drivetrain and suspension settings unchanged.

Compatibility

Compatible with Inferno MP11 chassis models that use the one-piece engine mount configuration, check your chassis code to confirm MP11 layout before ordering.

Use standard thread-lock where applicable, inspect mounting screw threads and chassis locating tabs during fitment, and keep the part free of excessive contamination to retain consistent engine positioning.