Kyosho LA410 Bulkhead Set (ZX7.5) rear bulkhead for LAZER ZX7.5  [KY-LA410]

Rear bulkhead for LAZER ZX7.5

The Kyosho LA410 Bulkhead Set is an RC-scale replacement intended for use with the LAZER ZX7.5 chassis. It serves as the structural locating point for rear assemblies and is intended as a direct-fit spare to restore original mounting geometry.

This part is meant to support precise alignment of rear components during routine maintenance or setup changes. In practical terms the bulkhead locates suspension pick-up points and the rear drivetrain interfaces, helping preserve intended handling characteristics after component replacement or repair.

Installation notes: prepare the chassis by removing the rear cover and old bulkhead, verify mating surfaces are clean, and re-use original mounting hardware unless the seller specifies inclusion of new fasteners. After fitting, re-check wheel alignment and suspension travel to confirm expected geometry has been restored.