Kyosho LAB07LWB Non-Decoration Body (ZX7.5 Lightweight) for LAZER ZX series  [KY-LAB07LWB]

Non-Decoration Lightweight Body for LAZER ZX Series

This Kyosho LAB07LWB non-decoration body is an unpainted, untrimmed replacement shell intended for LAZER ZX series models. It is supplied as a lightweight body panel primarily for hobbyists who need a direct spare or a base for custom trimming and paintwork.

Intended use and role: the part serves as a structural outer shell at RC scale, allowing quick replacement after damage, or providing a neutral canvas for aerodynamic adjustments during setup. The non-decorated finish means no factory graphics are applied, so trimming, mounting hole alignment, and personal finishing are expected tasks during installation.

Installation notes: align existing body mounts and mark factory hole positions before final trimming. Confirm fit on your LAZER ZX chassis and test clearance over suspension and servo linkages before final fixing. Use appropriate body clips and energy-absorbing mounts if your setup requires additional damping.

Tuning considerations: because this is a lightweight body, expect modest changes to aerodynamic balance and inertia compared with heavier decorated shells. Use it as a baseline when evaluating handling differences after body swaps, and combine with small changes to ride height or wing angle to dial in handling.

This component is presented as a practical spare and modifiable base shell for LAZER ZX platforms, aimed at reliable replacement and iterative tuning rather than cosmetic finish out of the box.