Kyosho LAW57B - Stabilizer Set(1.7-2.0/ZX7.5)  [KY-LAW57B]

Stabilizer set for rear roll tuning

This stabilizer set is an RC-scale replacement part supplied under the Kyosho LAW57B identifier and carries the sizing designation shown in the product name. It is intended for use where a selectable stabilizer diameter or profile is required to adjust rear roll characteristics on compatible LAZER ZX series models.

Functionally the set serves as a tuning component to change lateral stiffness and roll transition at the rear axle. Swapping between the listed sizes alters how the chassis transfers weight during cornering, allowing riders to refine balance between grip and rotation without changing suspension geometry.

Installation is straightforward for hobbyists familiar with 1/10 electric RC maintenance: remove the stock rear stabilizer linkage, fit the LAW57B components to the stabilizer mounts, and verify clearance through full suspension travel. Use standard RC tools such as hex drivers and a small spanner as required by your chassis; check thread engagement and retighten after initial test runs.

When tuning, make incremental changes and test on a representative surface. Smaller stabilizer values in the set will typically reduce rear roll stiffness leading to easier rotation, while larger values increase resistance to roll, improving stability at the cost of rotation.