Kyosho LAW88-03 - Adjust Screw & Spring Set (ZX7.5) for LAW88 one-way slipper clutch  [KY-LAW88-03]

Kyosho LAW88-03 - Adjust Screw & Spring Set (ZX7.5)
Price:
USD$0.00
Brand:
Kyosho
Model:
KY-LAW88-03
GTIN:
4548565524600
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Adjust Screw & Spring Set for LAW88 slipper

This Kyosho replacement set supplies the adjust screw and spring components intended for use with the LAW88 one-way slipper clutch in RC models. As RC-scale parts, these items serve the mechanical function of setting preload and engagement behaviour inside a slipper assembly rather than altering primary drive components.

Use the set to refresh worn adjusters or springs, to restore predictable slipper engagement, or as part of incremental tuning when you want to refine traction transfer. The adjust screw controls preload and the spring sets resistance against slip; small changes to screw position produce measurable changes in engagement feel.

Installation notes: remove the slipper housing per your chassis manual, exchange the old adjust screw and spring for the new pieces, and reassemble. Verify engagement in small adjustments rather than large changes, and test on a bench or low-speed run before full use. This product is intended specifically for the LAW88 one-way slipper clutch assembly.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which clutch does this set fit?

This set is for the LAW88 one-way slipper clutch assembly only, intended to replace the adjust screw and its spring inside that specific clutch.

Do I need special tools to install it?

Basic hand tools used for slipper maintenance are sufficient, such as the hex driver or small screwdriver that matches your slipper adjust screw head, and a clean workspace for reassembly.

How should I approach tuning with this set?

Make small incremental changes to the adjust screw and test engagement after each step; document positions so you can return to a baseline if needed.

What maintenance is recommended?

Inspect the screw and spring for wear or corrosion during regular slipper servicing, clean mating surfaces, and replace the set if engagement becomes inconsistent.

Copyright © 2008-2026 rcjaz.com All rights reserved