This Kyosho LAW93GM replacement part is an aluminum front suspension holder D produced for the LAZER SB line, finished in gunmetal. It serves as a direct-fit mounting point in the front suspension assembly on LAZER SB models where the original holder has been damaged or where a stiffer mounting surface is desired for setup consistency.
The component's role is mechanical and precise: it locates suspension arms and shock mounts, maintains alignment under load, and provides a repeatable reference for tuning. Use it as a like-for-like spare when restoring original geometry after an impact or when refining front-end compliance during setup sessions.
Fitment follows standard front-end service practice: remove the damaged holder, clean mating surfaces, and transfer any stock bushings or inserts if present. Hand-start mounting screws to ensure correct thread engagement, then torque to the vehicle maker's recommended settings if available. Check suspension travel and steering geometry after installation and test with low-speed runs before full-power use.
From a tuning perspective, swapping to a rigid aluminum holder can reduce unwanted flex at the front, helping maintain camber and toe under braking and cornering. Combine with correct shock mounting position and arm shims to dial handling balance rather than relying on body flex or soft components to compensate.
Inspect the holder for visible cracks, stripped threads, or deformation after impacts. Keep fasteners clean and apply thread-lock where appropriate for metal-to-metal joints. Replace if the part shows permanent damage to ensure suspension geometry remains consistent.
Copyright © 2008-2026 rcjaz.com All rights reserved
