Kyosho Mini Inferno / Mini Inferno 09 Graphite Rear Damper Plate with Screws & Lock Nuts by GPM GMIF030  [GMIF030]

Graphite rear damper plate

This graphite rear damper plate is an RC-scale replacement part made for Kyosho Mini Inferno and Mini Inferno 09 platforms, supplied as a 1pc set with matching screws and lock nuts. The plate serves as a mounting point for rear shock assemblies and helps maintain alignment between the shock tower and chassis during setup changes.

Material and role: the plate is produced in graphite to provide a balance of light weight and structural stiffness suitable for small-bore racing and hobby running, and it is intended strictly for model suspension tuning, not for any real vehicle application.

Compatibility and fit: designed specifically for Mini Inferno / Mini Inferno 09 configurations, the plate matches standard shock mounting holes used on those chassis; verify hole spacing on your existing tower before installation to ensure direct fit.

Installation notes: replace the stock rear damper plate by removing the existing screws, align the graphite plate with the shock tower holes, and secure using the supplied screws and lock nuts; hand-start fasteners and tighten progressively to avoid misalignment. Use the correct-size hex driver for the supplied screws and check lock nut security after initial runs.

Tuning considerations: swapping to a graphite plate can slightly alter flex characteristics at the rear shock mount, so expect small changes in rear end feel; use it alongside shock oil, spring, and mounting position adjustments to dial handling to your setup preferences.