This is a single 1 pcs replacement motor gear manufactured by GPM for the Kyosho Mini Inferno platform, specified as a 12T motor gear made from titanium. The part is supplied as one piece and intended as a direct spare for Mini Inferno setups where a 12-tooth motor pinion is required.
Use this gear when replacing a worn motor pinion or when testing small changes to final drive ratios during tuning. The titanium construction is noted in the product name and is referenced here only as the material attribute; installers should confirm proper shaft fit and gear mesh before full operation to avoid premature wear on adjacent components.
Installation notes: fit the pinion to the motor shaft in the same orientation as the removed unit, check axial alignment with the spur gear, and verify secure seating of any set screw or retention feature that your motor uses. After installation, rotate the drivetrain by hand to confirm smooth engagement and correct mesh before powered runs.
Copyright © 2008-2026 rcjaz.com All rights reserved
