This is a single 16T titanium motor gear produced by GPM for Kyosho Mini Inferno applications, supplied as 1 pcs set. It is a scale RC motor accessory designed to replace the stock pinion to change gear ratio or refresh a worn part without altering the motor or spur gear geometry.
Use this gear when you want finer control over final drive ratio or when replacing a corroded or rounded stock gear. Titanium offers dimensional stability and resistance to deformation compared with standard steel alloys, helping preserve tooth profile under normal RC running conditions. The part is intended for hobby-grade electric RC setups only.
Installation notes: fit the gear onto the motor shaft ensuring correct seating, verify backlash against the spur gear, and secure the set screw before a test run. Check mesh and motor temperature during initial runs and recheck the screw after a few laps to confirm retention.
Copyright © 2008-2026 rcjaz.com All rights reserved
